Salt Reading Desk

Which IntelliChlor salt target should I use?

Check the model on the cell, distinguish a status light from a measurement and read the Pentair target.

Read the model name before using a target

For the IC15, IC20, IC40 and IC60 named in the linked installation guide, Pentair identifies 3,600 ppm as the ideal. Its water-chemistry table lists 3,600–4,500 ppm in the salt row. The same page has a separate total dissolved solids row. Copy the figure from the salt row.

The Plus and LT family has a separate source. Pentair also gives 3,600 ppm as ideal for that family. On older equipment with salt status lights, record the observed light and obtain a numerical independent test. A status range has no single equivalent ppm value.

Why the chosen model matters

Suppose a shop measures 3,200 ppm. A classic AquaRite salt chart with a 3,200 ppm target shows no gap. For an IC40 using the cited Pentair manual, the same number is 400 ppm below ideal. This difference exists before anyone estimates the pool volume.

Record the reading as the equipment shows it

Select the model in the worksheet and choose “Status light only” when appropriate. Enter the separate salt test and keep the cell light in the notes. Verify a repeat test and resolve conflicting evidence before using a calculated mass. Where the installed product has a different manual, choose the custom target and copy its ideal figure.

Salt readings worksheet

Related guides